3 in 1 skin care Vacuum Spray Diamond Micro Dermabrasion skin peeling machine CV01-Oxygen Hydrogen-Beijing Zohonice Beauty Equipment Co.Ltd-LASER IPL MACHINE

3 in 1 skin care Vacuum Spray Diamond Micro Dermabrasion skin peeling machine CV01

Treatment range
1. Aging and sun-damaged skin
2. Some types of acne scarring and acne
3. Altered pigmentation
4. Stretch marks
5. Fine lines
6. Enlarged and clogged pores

Theory
Provides a non-surgical skin refinish procedure, by using sterile diamond heads to abrade or rub off the top skin layer, then vacuuming out the particles along with any dirt and dead skin backup. This procedure removes skin debris, imperfections,blemishes, wrinkles and unwanted pigmentation on the skin. Moderate usage of Diamond Microdermabrasion, accompanied with skin products that penetrate through the top skin layer that reach the dermis level, helps to replenish natural nutrients, restore cell activity, and promote skin health. The results after a Diamond Microdermabrasion treatment are healthy, glowing, beautiful skin.

+86-13910911829 +86-13311332377

or click here for free,no obligation quote

FREE QUOTE

View operate technical video

Facebook

LASER IPL MACHINE

VISIT

---Specification---

Parts Name	Quantity
Diamond Dermabrasion Machine	1
PVC vacuum hose8*5	1
Diamond pen	3
Pens box & foam	1
Diamond Head	9
Heads box & foam	1
Cotton Filter	1 package
Power cord	1
Fuse	3
O-rings	3
package	302320cm
gross weight	2.3kg

---Operate Guide---

Operation
1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 8*5 size vacuum hose. Then push in the black plastic ring on the vacuum hose.
2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the movable ring and insert in the vacuum hose to the limit.
3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.
4. Turn on the power switch.
5. Adjust the Vacuum intensity by Vacuum Regulator according to the following reference table, the intensity displays on Vacuum gauge and check with the client for comfort.
Guide
6. Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing so will cause harm to the skin.
7. Adjust the crystal flow rate by the Vacuum Regulator slowly from minimum to maximum. For commonly use, do not set the flow rate to maximum unless it is of necessity. This is for better comfort intensity.
8. Gently stretch the skin with thumb and finger and glide the Hand-piece 2 to 3 times over the area being treated. Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.
9. After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel.
10. Allow skin to dry then apply desired skin product.
11. To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilization.